RELM PM4500 Manual de Instruções descarregar pdf (Página 14)

Press and

hold

ESCAPE. The Programmer’s

display will show a characteristic Test Pattern with

all segments on, thus:

and then revert to:

in the display when ESCAPE is released.

After Programming or Cloning is completed:

1. Turn Transceiver power off.

2. Remove inter-connecting cable from

transceiver.

This feature permits duplicating (cloning) the same

programmed data into any number of transceivers.

Be sure to use the proper Start-up (see PRELIMI-

NARIES, page 5) and Unit Turn Off procedures

(above) when cloning.

NOTE: The CLONE key toggles from the

Read function to the Wrlte function, or

vice versa, each time it is pressed.

If a Transceiver a/ready contains the data to be

cloned, connect it to the PM4500 and proceed with

Step 3 on page 26, using proper Start-up proce-

dure.

1 2 ... 9 10 11 12 13 14 15 16

Sem comentários

RELM PM4500 Manual de Instruções Página 14